I ran these through Skeinforge…
I ran these through Skeinforge and there doesn't seem like anything to print. ???
View ArticleI just downloaded the base…
I just downloaded the base plate directly from Thingiverse and it is 100% fine.The units are in inches not millimeters.The base should be 2x3 inches.
View ArticleI don't think Skeinforge…
I don't think Skeinforge supports inches. It should probably be scaled up.
View ArticleI believe mini magics will…
I believe mini magics will save it to a mm part as long as you are using mm units in the settings.
View ArticleJust confirmed mini magics…
Just confirmed mini magics will save files with units in inches to files with units in mm.I attached four more files with units in mm.
View ArticleI printed one on my repman.…
I printed one on my repman. But had to turn the caps upside down to make them printable. Also some fileing was needed to make them fit. Otherwise its fine :-)
View ArticleOne with Makerbot. The text…
One with Makerbot. The text was too fine to print and caused few problems. Knife and files came in handy when opening holes/tuning the knobs. But it works :)Also big thanks to Nick Ames for oozebane...
View ArticleAnother video (of one made…
Another video (of one made on a Makerbot) here: http://www.youtube.com/watch?v=N5SouIMDtUU
View Article
More Pages to Explore .....